Hondata

In my case, I did not change any wiring whatsoever when it started happening. I have a GM 3bar, and it had also been there for quite some time before the problem started occuring

Sorry man.. I never did figure it out. I thought it might have been the boost controller telling the wastegate to open, but that wasn't it. I thought it might habve been a weird freakish-problem with the wastedate, but that wasn't it. I know it was boost cut... but I could not for the life of me get ...

WEll, after talking to someone at hondata, I tried out a friend's 4b blue box. I also burnt the same program (with boost cut disabled) on a whole different chip.

Worked fine for about 15 minutes, then boost cut started kicking ing. Any ideas? I'm trying so hard to hit that 11 sec timeslip before ...

Fooring it in neutral (at least, flooring it while its not in gear/clutch is in) is exactly what you do when you're using the 2-step at the drag strip. I had my buddy's 2-step hooked up (from his 4b) for a while a long time ago, and it was behaving exactly like that: a 2-step rev-limit.

The wiring ...

I've got a 2bd system on a p30 running my turbo GSR setup.

I am hitting boost cut when I reach 20psi... its definitely boost cut (its like I let off the gas pedal). My friend has a 4b, and we loaded the program off of the chip in my ecu, and the boost cut option is disabled.

Why would I hit boost ...

If you plug in a 29c256 backwards it will get very hot and usually fail afterwards. If the programmer can program other 29c256 chips then both your chips are bad, otherwise it is the programmer.

that's probably what happened.... I don't have any more chips to try, but the programmer works with ...

Do these things go bad regularly? I have 2 of them, and as of yesterday I cannot program either of them. 2 days ago, I could write a program to one of them, and now when I try, it fills the window with the "xx found, expected xx" messages and will not program the chip. I can still successfully use ...

I se the voltage ->< lambda mapping on the techedge main page... but what values do you use? The hondata screen to enter th wWB voltage mappings doe not use nearly as many as the techedge page provides.... do you jut do 1, skip 2, do 1, etc? What table did you use?