Hondata

What an active forum,
thx admins

Hi everybody,

i tuned my ecu and i have good results, can somebody have a look and fine tune it for me please, or give some advice if it can be tuned better according to your experience?
the car is k20a2 with cold air intake, DC racing headers
The kal is attached and the datalog
datalog:
http ...

Can't we do any wiring to give a signal to activate the reverse lock???
because i've heard that we can switch the wire of the reverse cable and put it a the nitrous switch and activate the nitrous from the kpro and it will work. anybody heard about it? or can i activate it manually?

The base one didn't work well, it was too lean maybe because of the cai and the race header and the 98 octane we have. I added some fuel first the lean cuts decreased but didn't gain power. Check the kal posted above they may b better.
Till now I'm facing some problems in knocking. Check my new ...

HI again,

i did a long datalog but it stopped automatically on the 8mb, ill do another one if u wish and post it again. it went well some knocks but much better than before, i had 2 lean cuts on the 6th gear around 3000rpm,

thanks again keto06

http://www.speedyshare.com/files/25804166/full ...

Thank you keto06, i will asap

sorry man, it's my first time :D

here it is

I did, it is posted named cai - tuned after calibration

HI Keto06,

i loaded the cai tuned map, and started dataloging, it seems so lean because its cutting off fuel(attached) maybe because we have 98 octane fuel, I couldn’t continue data logging. So I installed another map( k20z cai tuned) and tried, same problem + V tec sensor error and the vtec ...

I installed the wideband and made the modification in wiring, but the euro type r maps didnt work and didnt read A/F sensor, so i installed k20a2 rsx maps, i tried the cai tuned on third gear and the k20a stock map, and dataloged on third gear( attached). please check them up and advice. But i have ...

I ordered a wideband sensor from denso, but can anything can b done for the 6th gear security pin? Not to shift the reverse by mistake and brake my gearbox, because the PNF is a 5 speed ECU
Thank you

When i installed the headers i've lost the low end torque but i gained on high revving on a stock ecu, now i bought a k-pro, can anyone send me a proper cal to get the best hp and torque for such a tune.

it is a euro type r
Thank you

Hi
Does a k-pro modified PNF ecu (02-04 civic SI) fit a 04 Euro type r?