Hondata

Thanks Spunkster :)

Hi, can anyone can confirm if upgrading from FPM V1.1.5.6 to V1.1.8.5 will cause any settings (fuel, ignition maps, etc..) to be changed back to default settings or anything like that?

Thanks.

bump...

Hondata wrote:Ok, post your calibration and a datalog for us to look at.

Hi, here is the datalog and calibration files for my S2K for your review.

Thanks.

Spunkster wrote:Have you cut the wire that originally went to the ELD?

Nope... I just removed the original ELD wire from the ECU connector and replaced it with the LC-1 wideband analog output wire. After that which I disable the ELD checkbox in the FPM as stated in the Hondata helpfile.

Yes, I should think so... I have confirmed the placement of the ELD wire and checked the neighboring wires colour code around the ELD with the factory manual. All the colour code matches as what it should in the factory manual so I'm pretty sure I couldn't got the wrong wire.

I have used the multi ...

Hi,

What my side did was to follow as per your instruction found on the site: http://www.hondata.com/help/flashpro/in ... erface.htm

The LC1 output wire is connected to ELD pin position in the ECU connector and the LC1 voltage output was programmed as 0V = 10:1 and 5V = 20:1

Hi,

I have a problem getting Innovate LC-1 wideband sensor working and displaying on the FlashPro Manager.

This is my S2000 detail:

Model: '08 S2000 DBW (Asia)
Engine: F22C
FlashPro Manager: v1.1.5.6
FlashPro: FP-S2K-INT

I have followed Hondata's instruction on wiring the aftermarket wideband ...