Hondata

JSRC / HONDATA s200 and No Glory
I've had idle issues from the get go. Mostly Idling, Vtec Pressure and Vtec spool errors.
The car is running really rich right now and throwing error 9 in the hondalogger software.

I'm running the big boost tune from hondata for the Jackson Racing Supercharger ...

How long did you have the AEM FPR before the diaphragm went out?
I'm having a similiar problem. All of the sudden, I'm running WAY ritch.

I'm having pretty good luck with the P28 ECU and the H22 engine.
I had ODBII though. So you would need a different harness than I have.

pull the negative battery cable off for a few, then reconnect.

Error CODE Description
21 VTS VTEC spool
22 VTP VTEC pressure

VTEC setup in RomEditor is:
Fixed VTEC Point @2500 RPM
Minimum load, only change cams if engine load is above 1299 mbar
The spool light comes on at 1500mbar and 4539 RPMs
The VTP error happens right after.
IAB secondary intake runner ...

This may help you out on the pinouts

The original question still hasn't been answered. I'm interested in this as well. I've tried to use this featue with poor results. I keep getting tunes that bog the engine really bad. Are we supposed to just drive around and then save the tune or do a pull and save the tune? If anyone gas a ...

Did everything suggested. Soldered all connections. Hooked up power and ground to the ECU and upgraded the software to the latest rev.
The soldering fixed my voltage discrepancy problem and the software update fixed the rest.

Thanks much.

Nope, you need to download the latest versions of Hondalogger and Rom editor, they have the PLX M series listed there next to the FJO and the Motec, U DO NOT NEED THE CUSTOM TABLES, there is a selection for the PLX
Do you have a link to this software? I have tried to download the software from the ...

Pretty sure that I have the latest software, hondalogger is v3.5.0.0 and the ROM editor software is v3.1.5.0

As for the the selection for the PLX devices wideband in the EDIT CONVERSION TABLE in the lambda section of the SETTINGS, are you referring to the Custom selection? I also have this set ...

Sound like the same problem described here.
http://hondata.com/bb/viewtopic.php?t=911

Yes the exact problem.
Question? Why is Hondata letting them label this device as Tested and Approved , when clearly there is a problem with the datalogging application. Does everyone have this problem, or is ...

Methods
I have removed my stock O2 and replaced it with the PLX m-200 , and hooked up the wideband output. The HondaLogger software sees a constant 3.809v. This keeps the Lambda at a constant 14.49 in the dash display of the software after editing the lambda conversion tables.

I'm interested in the ...

I have removed my stock O2 and replaced it with the PLX m-200 , and hooked up the wideband output wire to D7 on the Stock wiring harness. I have an odb2 to odb1 adapter harness to a P28 ECU.
The HondaLogger software sees a constant 3.809v. This keeps the Lambda at a constant 14.49 in the dash ...