Hondata

Thanks, I will have a play with it

I just updated to the latest FP version, and the fuel gauge is doing strange things as well, it was never accurate with the race Cal but now it is erratic and basically stays below half even when the tank is full, some times the gauge moves up and down slowly as I drive along very strange

I have a 2007 FN2 & am fitting the TC
My workshop manual wiring diagram for the ABS is different from the wiring in my car from left to right the first 3 pairs are the same but the last (red & white) is different can someone help me please as to what wire is what
traction control wiring 2.jpg

I have an Innovate motorsport LC1 on my FN2 to monitor afr`s and I used pin A23 ELD. Switch off the ELD parameter in flashpro.
All the other pinouts cannot be used on the FN2.
Make sure the ground is routed to ground location 101 intake manifold bolt for the ecu.
I had a serious voltage offset ...

Is the wiring diagram in flash pro help for the ECU are the pin positions ect the same for the FN2 ECU ( I have the latest software)
I have an innovative MTX-L wide band 02 sensor & guage & want to connect it up to compare with the stock 02 sensor, I understand that it will be only for data logging ...

I went over to the tuners made sure he had the latest software, tried to upload map & had the message (turn the ignition on)
The engine cranks over but does not start
The Flash Pro Manager sees the Flash Pro but not the ECU (red cross)
The tuner has sent an e-mail through to you using the latest ...

I received my flashpro & ECU back I uploaded the map & everything was fine. I had to wait a while as the tuner is very busy & yesterday I drove my car to the tuner & the same thing has happened agian, I have e mailed Matt & the tuner has e mailed from the software
He is concerned as to what happened ...

Yes I have from Matt, sent it last Friday, you should just about have it by now

I had a similar problem & have just sent the ECU & flash pro off to Hondata
Has it been sorted out yet

Please have the tuner download the newest beta version of software from our website and see if that works. If there is still a problem have him send the support information again using the new version.

The tuner has tried the latest beta software & still has the same problem, he has sent another ...

The tuner has sored out the idling problems & has completed the tune, he was just uploading the final map when the red cross under the ecu came up & now the car cranks but does not start
He has tried re installing, software ect but there has been no luck
Battery is fully charged & he has tried ...

After many small hassels I finally have the SC fitted The dyno tuning people have just rang me about the supplied base map & said it did not have a closed loop added so the car does not idle properly (hopefully I got it right)
As I do not know much about it & I can not find a map that is close to to ...

joel1188 wrote:hi

take a look at this, i should be able to help you

http://www.civinfo.com/forum/type-r/410 ... o-day.html


thanks
joel

Thank you very much
Ian

I have just received a complete kit with Rotrex 30-94 unit, 7.50 injectors, fuel pump, intercooler ect
Flash Pro with starter map
I have full exhaust sytem, headers ect
Forged pistons & rods
I live in Perth Western Australia, & have been to a lot of dyno tuning places to see if they can finish off ...