Hondata

Alright. Will email the detail.

I got internal short at U1. 5V from cn2 to U1 LPC1768FBD100 pin 88.. Resistance form GND to 5V should be R43 10K. Do Hondata sell spare part for replacement U1?

T try new hondata today. Sure ecu is ok. I got faulty hondata that not detect the ecu it turn ON.

The new hondata will light up LED D3 static after Ignition key is on, and LED D2 will blinging after usb is plugin.

VtecGarage wrote: Fri Dec 23, 2022 3:28 pm Exact same problem Im having too

Have you try difference ecu? I tried 3 known working ecu no luck

Spunkster wrote: Fri Dec 23, 2022 10:09 am What is the part number of the ECU this is installed in?

ECU P30-N01
S300J 5335 white board
Smanager V2.8.1.0 build 2966

Hello and good day all. I have hondata s300 v3 JDM that cannot upload and datalog. The button for upload and datalog grey out cannot click. Only can view s300 information that not show any problem.

Car running well no check light. The problem only cannot do anything to tune...i try with others 3 ...

Can you suggest which international dealer is nears to Malaysia?

These ecu i buy from internet in Malaysia. It only work like month, then the ecu start intermittent datalogging issue. Now it cannot datalog completely

37820-PRC-013
2070-201915 0L03



Can these ecu reset to factory setting? maybe like obd1 remove J1 just to look either the ecu ok?

No i it not enable i will try to enable it

Already done erase ecu, close the kmanager, and re upload same calibration to ecu. Same click start datalog it automatically stop. And click again it not stop the datalog. But there no data display.

I try with fresh start calibration file also same. When datalog, the green led is turning OFF, red ...

Spunkster wrote: Fri Jun 18, 2021 9:54 am From Help, About, what is the version of software you are using?

KManager version is 4.4.6.0

https://pasteboard.co/K7fbIQm.png

Serial Number : 05004057
KPro Version: 2

Upload and download no problem, the table look good. and no sign corrupt data.

Hello and good day, i have Kpro that can datalog but dont have any data received and display in KManager. I tried programmer troubleshooting and get:

Green LED Red LED
ON Blinking ---------- when usb connected, ig power ON but datalog not start.
OFF Blinking ---------- After start datalog and ...