Hondata

I got it to start up and run with that.

I looked at my VE tables and I guess after you change the MAP settings, it rescales everything and changes it. I copied my old tune in to the correct values for my fuel and ignition. It ran very very rough though.

I just put the stock one back in and I'll ...

Well I did a little bit more searching and found this thread which I think has my answer. I will reply if I can get it to work with these values.

http://forum.aempower.com/forum/index.php/topic,22339.0.html

Map min voltage 0.50
Map max voltage 4.80
map filter 15
Load offset 0.20
Load scalar 4.00 ...

Okay. I will probably end up going that route.

Out of curiosity, what Scalar and Offset values do you use on the KPro for the 4 bar map sensor?

Thanks again
-T.J.

Hello, I have a 2000 s2000. I am running an AEM EMS 1052 for engine management. As far as mods go, it may as well be considered stock. Just exhaust bolt-ons and nitrous which is tuned through the nitrous control.

I recently bought a Hondata 4 bar MAP sensor since I will be going FI in a few months ...