Hondata

Hey people,

I have a strange problem, I hooked up my wideband (Innovate LC-1) to my car.

I set the two analog outputs the same, both:
- 0 V = 7.35 AFR
- 5 V = 22.39 AFR
like the default settings for the gauge.

Now I can get it right in Kpro with a voltage offset of 0.58 when running stationary ...

Spunkster wrote:Was the wire that goes to the ELD cut?

Yup it was.

We're going to check tonight that everything is ok before the resistor thingie.

Hey,

I bought an Innovate LM-1 and yesterday I had a mecanic install it. Output on ELD pin 15.

Now once I start it up and it's heated, it always reads the same value. It doesnt change to the AFR value while driving, it just stays the same.

I used the serial cable to read AFR's and that works fine ...