Hondata

Well, it was the plugs! Car is running great now. Pretty sure it was due to a corrupt tune that couldn't read any sensor data (could have been one of several) and started dumping mad amounts of fuel.

All is well! Thanks for the help

http://i547.photobucket.com/albums/hh442/baudchaser/plug.jpg

Plug was definitely wet when I pulled it, just didn't snap the pic in time. So hopefully this is why it won't start...question now is, what contributed to the rich condition....coulda been the corrupted tune, or fucked up ECT/Fan sensor ...

Battery is fully charged now, but I can't get the engine to come to life for even a second now. Pulling plugs now...unfortunately don't have a means to perform a compression test myself.

Well, I cranked the car with gas at full throttle to put the car into "clear mode" and keep the injectors from pulsing -- after doing this, the car actually was able to start for a couple seconds before dying....b/c now I've drained my battery.

So now that the ECU is reading, I'm hoping that it's ...

OK...cleared the ECU and uploaded my previously working map.

I can now see sensor data in KManager, but car won't start....wondering if I fouled up my plugs from running extremely rich for a day?

How long does it take to upload a map? It sounds to me like the ECU has a bad map in it. I would clear the security and wait 2 minutes with the key off and then attemp to re-upload a map. The meter when uploading should take a long time.

Thanks for the reply Justin -- I did actually notice the ...

Car won't start this morning, so I can't get the exact code from K-Pro, but the only one I was getting previously was for secondary O2 (b/c of the race header).

Tried unplugging both the ECU & battery, multiple times for several minutes.

Visual inspection of some of the fuses (about to go do more ...

K-Pro Serial: 06957
KManager Vers: 2.02
Calibration: Stock
Datalog: Can't get one...
Vehicle: '03 Type-S
ECU: '03 Type-S
Modifications: I/RH/E/Motor Mounts

Symptoms:

(1) I can connect to, and upload/download calibrations to K-Pro, but when I try and datalog, there is no data (rpms, MAP, etc stay ...