Hondata

is it showing a cel light?did you get the correct 02 sensor? the us , jdm spec sensor,

cheers m8, thankyou

as above on a k20a2 eg with a us spec prb k pro,i am wanting to buy 1 of these but dont no how to wire them up,any 1 no how to wire it up??
all help much apreciated
thanks

kb58 wrote:Don't assume you broke it... it could be wiring (broken lead, intermittant connection, etc.)

thanks for your reply,what should i recheck on the wiring.it is intermittant at times,what should i check for this?

im getting the car a fresh retune next month i was just wondering if i should wait till the day i get the remap to install the new 02 sensor just incase i brake this 1 too.?

hankyou for your help

thanks for the reply,wires have been checked and are all good,running a hybrid harness with us spec kpro version 1.2.24
will updating the ecu help??

hi guys,i have a k20a2 eg with a us spec kpro installed,i had a p0134 code,so i bought this sensor off ebay,item number 130371089969 .installed it and its doin the same as the origanel sensor did,coming up with a cel,but this 1 runs lumpy at low revs when driving,my origanel sensor was a denso japan ...

thankyou very much mate,so all i need to do is update the software to my ecu,then retune it on the rollers.correct?

ok guys,my car was throwing a p0134 code,so i changed the primary 02 sensor for a new 1 and still the cel light keeps apearing sometimes but not all the time,it will come on 1 day and might not come back on till 2days later,if it does come on i just knock the engine off and switch it back on the ...

right lads plugged laptop into ecu and fired her up and a error code has appeared saying 39.1 p0600 multiplexer not present.
any ideas what this is
cheers

Engine over temperature condition
means its overheating i think.check these

Harness or connectors (The cooling fan circuit is open or shorted)
Cooling fan
Thermostat
Improper ignition timing
Engine coolant temperature sensor
Blocked radiator Blocked front end (Improper fitting of nose mask ...

i have downloaded the software kmanager 1.4.0.0 .is this the correct software??
cheers

i would mate but im new to the hondata scene and i havnt a clue about checking codes :(

hi there people,i have just bought a 1994 honda civic eg with a k20a2 conversion,ive had it for 2 month now and has never missed a beat until recently,1 day the car will be fine then next day il start up from cold then drive for 1 mile then the engine warning light appears,then if i switch the ...