Hondata

hello hondata team :)
plz may u help me , i need to use this ecu ( pic above ) to boost my car . is it ok or some Components must be added to the ECU for the PWM output to work?????? with turbo. if use wat is the components and where to get it ?
thx in advance

thank u :)
i did a few min datalog ( i was afraid to break my engine )
innovate lc1 to d10

no i'm not from eastern europ, i"m from lebanon:)
i did solve all the wiring problms ( obd2b to obd1 conversion harness , obd1 distributor, 2 wires iacv ,s300hondata ,...)
thank u sir for trying to help me
waitting u

:lol:
dear luke
first i want u to know no tuner in my country :) one dyno and it's far AND not good also plus honda v tec engines r not wElcome here people used to own
BMW , SUBARO ..... BUT honda is for ladies , u get my point
also i'm the only one have this s300 hondata plus this h22a7 engine ...

:(

help :)

ya :) may u help me plz .
i fixed all the problms ( distributor , timming ,...) and load the map the car pulls hard ,but the clutch died :) anyway
my setup same as ur's
- stock h22a7 , s300 hondata , 76 mm throtttle body ,lc1 wideband =d10 eld
i load (far2wired ) basemap but cams are dialled -2.5 ...

hello
may u answer my Q
TPS reading when the throttle is fully closed = 0 %
TPS reading when the throttle is fully open = 123 % and becomes red at the display bar
i adjust the throttle opening in order to read 100% at wot but its not full opened is that fine
or can i set the max reading of the tps ...

thank u , i rly appreciate ur help :)
i'll fix it tom
t c

hey
i connected the yellow wire ( analog 1 ) to the gauge not to d14 narrow band signal, i did it as the innovate manual . is that fine ?

thank u :)
i'll remove it, and find the voltage offset ( lc1 connectd to d10 ) do u have an idea how can i measue the voltage offset ,
i read many art , but complicated
anyway thx

This Image Depicts My ECU , gonna appreciate ur help to locate the R136 & R138 by red circles , then plz re apploud it back .

ya i know if i need to use D10 R136 and R138 shloud Be removed but before i install the lc1 my display was ELD = 5 v what i want to know if that means that this 2 R are already removed from the ECU .
second how can i measure the voltage offset and in the closed loop parameter THREE ROWS i need to ...

hey
i bought a modified p07ecu with s300 v1.4.1.0
display shows eld = 5 v so i wire the lc1 to D10
is that means that the ecu is already modified ( cut R12 and R18 resistors in the ecu )
i cant open the cover of the ecu ( sorry )
thank u in advace

thank u :)
ya i downloaded a new display , it might be t the problem
anyway i'll delete it and see if this works
thank u again