Hondata

Fitted RBC manifold with bigger throttle body to a k20a2 (uk spec).

I had to remove the TPS sensor from the stock throttle body and fit it to the new one using bolts.

Is there a way of calibrating the TPS using the Kpro ?

Thanks
Alan

I can't upload any of my KDL files ???

Is there something I'm missing

http://www.host10mb.com/MeVc1T
http://www.host10mb.com/L6mLp2

Alan

Looking for some help/advise on my Kpro Calibration. I have installed a K20 into an Elise and using a Kpro. A friend has given me a map from his car (same setup).

I have enclosed the files, any input welcome

Fueling seems very lean which i'm worried about but unsure the correct way to add fuel ?

I used the Hondata Tech Wiring page. It is wired up exactly the same.

Its been fine for 4 months as well and re checked all connections and continunity (Spelling) when the MIL came on.

I wired up one of my narrow band 02 sensors (heater circuit only) and held it in my hand, when engine starts it ...

Thanks for the reply. I take the after market 02 will be used for data logging and tunning.

I am 100% sure my wiring is correct. Use a relay etc for 02 sensor circuit. Can't say I'm still not worried.

The trouble I have is everyone over here has PRA ECU's ....

Would I be able to check with a ...

I am having some issues with my 02 Sensor and would appreciate your advise on a few areas.

Car
Lotus Elise with K20a2 Engine Conversion
PRC Ecu which has been Kpro'd
Engine was a British (PRA) Ecu but i converted the Loom to use the wideband 02 sensor as per the Hondata website.

Problem
I have ...