Hondata

No, this is not possible. You will need to get the K-Pro to properly tune this.


hi spunkster :

if i run complete k20a R block , can i use base rsx ecu flash it to k20a R spec ? (coz i think hondata k20a map will outperf a stock PRC ecu right ? ) i want use base rsx ecu coz it with a flash ...

hi hondata:
i have some questions here.
i have a k24a2 with k20a R head on it. I know Kpro is the best way to go .but i cant find any kpro tuner around my area.
so i guess i better just use flashed ecu then run it as is ?
can i use a base rsx ecu then reflash it to k24a2 with R head spec map ...

Spunkster wrote:Have you contacted PLX?

i have a question get me confused. hondata website said i should turn off O2 sensor heater. But PLX use LSU sensor. Borsh site said LSU should not turned off o2 heater . other wise will coz sensor burnet off.

hmm... what should i do ??

Help plz!

i installed PLX WB to my turbo b20 setup . but i blown 2 o2 sensors within 2weeks. i checked wire conection.but all wires seems fine ... what will coz blown O2 sensors ? maybe coz my car unturned ? high EGT ?

any input will help !

thx alot !!!

fixed !!

it was a wire from distrubor mixed.

thx alot!

hi :
i am new on this forum.
my setup is:

EK with
b16a with type r head.
apexi p18 kit.
255 walbo.
650cc inj.
hondata s300.
obd2a -> obd1 harness.

Car wont Pass 3700 rpm!!! (i tried on gear,not on gear,floor gas,part gas.)
I got a Crank angle sensor CEL.but cant fix the code.

i tried change ...