Hondata

Hi guys,.
Been running flashpro since it came out.
Recently i changed my intake and throttle body. Hybrid racing intake, grams 72mm TB.

Car was dyno tuned. Race MAP tune (MAF deleted) All good.

In the mornings when I go to start I get a vsa light and engine light.

Turn engine off and on, vsa ...

Thanks for the Reply.

Such a shame!! One step behind Kpro. . . We can not run ITBs, can not run 4-channel Wideband . . :-(

So, the only way to get acurate indivudual fuel tune for a Big Motor using FlashPro, would be to run parallel logs, with the AEM just there to monitor the individual AFR and ...

Can I run the AEM 4-Channel Wideband Air/Fuel UEGO Controller with the FlashPro?

Thanks

Hi mate,

Is the GruppeM your only mod?

What calibration were you running before the GruppeM?

Hi Hondata,

Any plans for a Boost By Gear feature for the FN2 ECU??

There are finaly some Specific Turbo Kits being developed for the FN2 and its a feature needed to get the most out of the kits....

Thanks for your time.

What are your mods mate?

civicRSA wrote:I can confirm that the B2 output for boost control does not work on the Euro RSP ECU. Neither does the EGRL for a wideband input work.

I am currently using a USDM Civic Si ecu for both these problems and it works great.

Did you try connect the widband to the ELD?

yes. the 91% is in all cars. It's 100% but don't know why only read as high as that.

When you are above 960 map pressure it's at column 10, only near the end goes down that and goes to column 9. Clean your air filter and you can see a improvement

normal.

So, no one can run Colum 10 From top to ...

nunoctr wrote:paulo your datalog is normal.

Normal?

So is it normal the Pedal at 91% max, and no colum 10 at WOT?

Wile on that subject,

I use a 70mm Sponn TB, and my presure is at 980mBar @ 3000rpms finishing at 945mBar @ 8600rpms

But..., I realised that at WOT, the throttle Pedal never goes past the 91% mark, and on the tables it doesnt go to colum 10 in High Cam (does on low cam)!

Thoughts??

k20z3si4dr wrote:there is a calibration in the newest version of flashpro manager. check it out.

Hi,

Dont see a IPS cal. Only a Skunk2 Stage 2 cal... Where did you see it?

Regards

Thanks HONDATA.

Now lets see ur Displays.

Here is one of mine:


[/img]

Regards

Could we not have a Display Template area?

Would be cool to see tha display people use...

Regards

Same for FN2 Hondata??

Regards

Shot....

My display on Fpro manager went nuts after uploading the latest software!!

Seams like it moved up the screen, now can even see or touch the sensor that were on top of the page...