Hondata

test your tps voltage at closed throttle. it should read .5 volts. i had the same problem after installing a BDL 70mm. the k pro was reading 0 and 100% but it was not at .5 volts. then the k pro said 1 and 109%.
i adjusted the tps, and then scaled the settings in k pro. it runs great now.

thanks!!

i just wont use the full throttle shift function tonight.
im going to tune it with a 100 shot in a couple weeks any way.

hey guys,

i have a stock internal k20a2 with cold air intake, dc header, 3 inch exhaust, pump, reg, lines, stock injectors. it runs ok on the stock tuned rsx base. im going to install my RBC and 70mm BDL throttle body tomorrow.

does anyone have a map they are willing to share or sell?


thanks ...

i have a question about using launch controll. i have a k20 swapped eg civic. i have the 1.2.3.5 version. all wiring for the stock clutch switch is there. i havent touched that.
i used the hybrid racing conversion harness. every thing is running well.
i just dont know which setting to use for my ...

thank you for the reply.

i assume you work for hondata, correct me if i am wrong.

is it safe to say that hondata will make these features compatable in the near future?

26 views and no body has anything to say?

come on guys, anything?

i am wondering if i can use the full throttle shift feature with the hondata nitrous control?

i know for the nitrous to be activated you have to be up to the minimum speed, rpm and throttle position.
when using the full throttle shift feature you can meet all of those standards.

i would hate to ...

im running a b16 turbo with an abd-0 pr3 stage 3b. at idle and light throttle i am getting CEL. if i touch the gas it goes away, but will return. there are no codes thrown.

the car also studders/misses at light throttle some times.....but i amassuming that is just because of not being tuned yet ...

my set up is b16a turbo, and hondata 3b.
im just wondering what pfr and plugs you guys can reccomend.

in the installation instructions it says to use a 1 to 1 rate fpr. i currently have the pos b&m command flow fpr which i belove is a 1 to 3 rate...not 100% sure though.

most people that i talk to ...