Hondata

There is no need, you can use the pre-made calibrations with SManager.

Just use the D16 basemap for the P28. It doesn't say "D16Y8" but honestly that is what I had my D16Y8 for a long time and it runs fine on it.

Just make sure to do the normal corrections such as injector size, ect ect and your ...

Doubt it without building up the bottom end and pushing more boost.

With a B16A2 (160HP) and Turbo boosting 8PSI you are looking at ballpark 230~260HP.

To get 300HP it would require some additional work.

I would personally be happy with the HP I posted above with the amount of cash you are going ...

Hello Everyone,

I am looking for a basemap for the following setup;

D16Y8 @ 10 PSI default timing of 12.
Stock Internals
RC 310 CC Injectors

I have tried to build a basemap off the P28 Z6 but there are so many differences that I am changing almost everything to get his car even close to 14.7 ...

Nevermind I found out what I was doing wrong.

I had the engine at 12 degrees which is from the factory. (Never changed it, just confirmed it)

However my Ignition speed table was still set for 16 in terms of the numbers used. I dropped the entire matrix about 4 steps and it's now running perfect ...

If you have oil in the exhaust then you have a mechanical problem with the engine.

It's not really oil per say, it's oil flakes from when I use to use the crap known as Greddy Blue Box which ran my engine very very rich.

The Engine is mechanically sound outside of the slight blow by in the turbo ...

Hello Everyone,

I will first say that yes I am a noob when it comes to certain aspects of tuning and I must say that while the Hondata unit it wonderful I find myself lost a little when it comes to SManager.

I have a D16Y8 running 310cc injectors and a Trust turbo.

I have done a basemap and have ...