Hondata

if your vehicle has 235cc injectors, change it to 235cc.. If you don't know how to tune, you shouldn't be messing with this. If you know how to tune, it should be done already.. You got buddies that know?? let them help.. Read the help file too, it help ALOT.. No harm intended man..

When reporting any s300 problems, please include:

- serial number of the s300 inside the ECU
- the calibration (as an attachment)
- a datalog of a problem (as an attachment)
- what sort of vehicle you have
- what sort of ECU you are using
- anything about the car which has been modified from ...

Hey, civicbynature.. Innovate motorsports has a supports page that can help you out too.. I would suggest going their just to get an idea..

I too have an MTX-L Innovate Motorsports Widebad Sensor.. My question is why would you hook up the Yel wire in the O2 pin??? I have the Yel wire hooked up in D10.. Now the Brown wire simulates the narrow band sensor, I have that wire (Brown) hooked up in the O2 pin.. How about we install it correct ...

O.k., Check this out Spunk. The Vehicle I have is a Civic EX Sedan with four wheel ABS, this ABS modulator/Acummulator is located on the Firewall really close to this GSR intake Manifold throttle Body, I have a short Ram intake with a Aluminum Radiator.. air Filter is located slightly behind the ...

O.k., here it goes

1995 Civic Ex Sedan
USDM B18C1
JDM P72 ECU
Hondata S300J
CTR cams
MTX-L Innovate WideBand Sensor.
External Coil (MSD).

There will be two Calibrations with two datalogs one is USDM Calibration and DataLog, the other is JDM Calibration and DataLog. Like I said before, Idle drops ...

Wrong datalog Sorry, will send again..

1995 Civic Ex Sedan
B18C1
CTR cmas
Hondata S300J on JDMP72 ECU
Innovate Wideband Sensor

Hello, I have a 1995 Civic Ex Sedan w/ USDM B18C1, CTR cams, Innovate Wideband Sensor, Hondata S300J on JDM P72 ECU.. My problem is when I switch on the A/C my idle drops to about 450-550 RPM and slowly goes up, but not to 850 RPM.. I have increased the slider for the IACV one increment at a time ...

Use the JDM P72 or USDM P72 calibration and tune from that..

Ground on Thermostat housing is done.. I played with the Voltage Offset in the Closed Loop tab on Perameters, by -.22 volts.. Seems to do the trick.. I just need a tune.. Colorado has plenty of country back roads.... : )

Hello,
B18C1
Civic Type R Cams(In & Ex)
Del Sol B16 Tranny
Hondata S300 JDM P72(Using JDMP72 Calibration)
Stock Exhaust
Stock Headers
Cheap Aftermarket Autozone Intake

I just installed my Innovate Motorsports MTX-L Wideband Sensor. Installation went good, calibration done. What I noticed is, the ...

Could be ur Turbo Oil Seal.. It's a big O-ring.. My friend had the same problem with his B18c1...

Alright... Good to know...

Beginning 2003, Honda started installing A/F Sensors in most of the vehicles. As of now, I belive all Hondas have them.. Whats the differrence in using a Honda OEM A/F Ratio sensor.. It's also a "five" pin sensor..