Hondata

Spunkster wrote:Q31 has nothing to do with the O2 heater. It is caused from swapping the plugs for the IAT and Purge valve.

so it wil run with it? or do i have to put a now one in

Spunkster wrote:Have you tried disabling the O2 heater?

yes i did
:?
bud i have seen that 1 part on the ecu is burn even in my stock 1
i have 2 1stock 1with s300 en bouth gav the same problem
q31 it was i think is burnt

i have a new laptop
bud the car gives code 41 & olsow baromitic pressor sensor & knock sensor to what is the problem....

i get the error code 41 i use a plug from a dead sensor ....
en now my laptop is fuckt by a can of coca cola

i have a d16z6 with skunk2 intake exhaust end hondata s300
now i have a air fuel ratio meter from aem bud how do i connect the bleu en white whire for dataloging to the s300
my car isn´t runny good to rich or to lean so help me pleas .....
greats from belguim

buy a PLX (hondata recommends it) and plug it in.
how to do that you can read on the hondata homepages.

best regards Luke

i have one from aem now
but i have 2 whires bleu en white ..... for dataloging.... help me ....how to conect to the s300

it reads verry lean in normal driving but pedal to ...

Luke wrote:you should try do tune without a wideband. that WILL NOT WORK!

you will damage the engine.

what do you mean with "fry farren"?

best regards Luke

so i need a wideband somthing els to?
ent then?

which errorcodes do you have?
do you have a wideband lambda meter?
do you know how to tune a car by yourself?

if not: take a tuner to help.

best regard from germany
Luke

from the injectors the other i have to look
no i dont have a wideband lambda meter
i wil be goiing to the dyno in 2 ...

thanks :?

hello
i just got my hondata s300 installed end i am looking foor an map for my d16z9 with skunk intake manifold b16b trothelbody exhaust feulpresser at 3.5bar en i want a good map for it i am new to hondata en dont want to f*ck up the car thats why y look for a goot map before i go start making ...