Hondata

What does the upgrade cost? I just picked up a V1 for $100

I own a 2004 TSX that I purchased as parts (mostly for a swap) but now I'm thinking of swapping the K24A2 into my 2003 Element.

I have seen a few questions asked here and there, but nothing answered concrete.

The Element is an Auto AWD. The TSX is a 6 speed. I've got both cars, and I can use ...

Which pin is the stock o2 sensor using now? I can't find another one for an o2 input in the S300 Guide

I more or less ignored those instructions, since they are for a PLX wideband. I am not removing my factory o2 sensor and replacing it with my AEM. I didn't think my AEM was able to do both narrow band, and wideband for data logging.

If I use D14, will this replace my stock o2 input?


Thanks for ...

[quote="Spunkster"]You shouldn't be using an analog input for a wideband. You should be using the available inputs listed in the closed loop tab.quote]

I am confused!

I thought the 2 analog inputs were the only way to connect my AEM wideband? So where do I connect my wideband, if not to these ...

Thanks for the info!

So what about setting up the other analog input? should I set up both?

ALso, when I go into Smanager under Parameters/closedloop and select B6 as my input source, if I try to set the voltage to 0.00/5.00/5.00 and then set the lambda to 10.00/20.00/20.00 the voltage goes right ...

I have an S300 on a P06. I am curious about soldering the ecu so I can use an analog input to connect my wideband.

The instructions tell me to remove R2 & R3 and replace them with a 1N4148 diode. I have the diodes and I am ready to go. My only problem is I can't figure out which way to install the ...

I am looking for a basemap for my B16 Vortec setup. I am running a stock B16 with RC 440 injectors. My Vortec has the 12psi pulley.

I just got my ECU (P06) and Hondata S300. Once I figure out how to tap in to an anolog input, I will be ready to tune a little


Thanks

thanks, ill look into getting one, i just wasnt sure, new to tuning, not new to honda. lol, does any of u know the area of the site where i could find directions on hooking up an aem uego to my s300? i was looking at getting one of them.

I too would like an answer to this question. I've looked at ...