Hondata

I have one at home I will post up tonight for a close to identical setup

jdm type-R k20a
RBC IM
Hytech Header
stock injectors
custom CAI
PrototypeRacing velocity stack

here is a comparison between my .kal & stock ITR .kal (no other changes or mods) FYI this is on a low reading dynapack - I ...

6spd_ek wrote:the fuel maps could benefit from being smoothed out & adjust the spark maps according to any knock & make sure to check your actual a/f

I will do mate i'll datalog a decent run and go from there, thanks for the help and advice

Hey all,

I'm new on here and wondering can anyone help me out with a suitable calibration or near as? All help greatly appreciated,here are the mods:

K20A-R DC5 JDM ENGINE

Stock itr cams
Hytec 76mm exhaust mani
Skunk Mega Power R 70mm exhaust system mani back
RBC Intake Manifold
Hi flow CAI
K ...

I have one at home I will post up tonight for a close to identical setup

jdm type-R k20a
RBC IM
Hytech Header
stock injectors
custom CAI
PrototypeRacing velocity stack

here is a comparison between my .kal & stock ITR .kal (no other changes or mods) FYI this is on a low reading dynapack - I ...

andres-eh2 wrote:i forget the specific name of the cal but i used the k20a2 itr cams, toda header one for a while and my car ran good. on the tuning day we did a basline on it and made 230, ended up with 238 uncorrected whp that day.

Jesus thats a very good figure,what mods were you running?

Sorry my bad 310 they are, already ran that map it's ok with a few tweaks but there's more in other maps so fortunately i downloaded another members 217whp map for a k20a2 with itr cams and seems to pull hard with no knocking between 2k-3k after a few tweaks. I know the compression ratios are ...

Hey all,

I'm new on here and wondering can anyone help me out with a suitable calibration or near as? All help greatly appreciated,here are the mods:

K20A-R DC5 JDM ENGINE

Stock itr cams
Hytec 76mm exhaust mani
Skunk Mega Power R 70mm exhaust system mani back
RBC Intake Manifold
Hi flow CAI
K-PRO ...