Hondata

I will try calling you guys tomorrow or my number is 414-581-2127/ Dave

I think the USB shorted out a couple of days ago on me, but not sure??
Serial number is 3880 for reference.
This happened as I was on my way to work and wanted to start datalogging with my laptop(which was on) and USB connected to Kpro; but the electrical cord not plugged in yet. I then plugged in ...

ver. 1.3.5.4 brought back my vtec, thank you-thank you!
Pulling hard once again!

I too lost my VTEC solenoid after version 1.3.5.0, I have a datalog with it working in the old Version, and then next day with new version and no vtec.
I updated to 1.3.5.4 and will see if we get it back tomorrow?
And just in case, I downloaded V1.3.4 as a backup in case it does not work. No vtec ...

Yes, this was just during cruising.
I have tried the new "TSX 04-05 Header cai" calibration and I see that the fuel overrun cutoff delay is set to 10, this is lower than before. Should it be 20 or 10?
Also on the new TSX calibrations, could you give us some info on the HP/TQ resulted from them. I ...

And if you see anything else that seems out of the ordinary or I did wrong, please let me know...please

Sorry here is some more information:
PRB ECU, I can get the Kpro serial tomorrow
K24a2 in an EK,
AEM CAI for K series
Stock TSX header with custom catalytic pipe and 2.75" exhaust to a 2.5" twin loop
hondata intake gasket
RSX-S throttle body
Hasport harness

Hello,
I am new here, but been playing with Kpro for awhile now. NICE product by the way... love it!!!
So, I have a stock K24a2 in an EK with the the VTC milled to around 6.04 mm.

Here is the problem:
I see in a data log that during cruising in 4th gear, the camcmd will suddenly jump to 45 deg ...