Hondata

WOOOHOOOO!!!

Not only was my EPS connector burt, but my ECM Harness was caught in the crossfire too. Luckily I had it wrapped with heat wrap or this would have been much worse. there were just a couple wires that had some damage. One of which was a Blk/wht wire that happend to be my ignition coil ...

thanks! I'm just getting back to check messages on forum. So far i've found a connector (EPS) that was melted due to the fact that the heat wrap came loose. Could that be the cause?? could that cause the ignition fuse to blow though???? Huuummmmm? Will also check on your suggestions. I really do ...

Thanks a lot! I guess I will have to break down and take my car somewhere.

thanks!

Hello everyone, just posting to see if KPRO could be the cause for my igniton fuse to keep blowing. I have a 2002 civic si with a Full-Race turbo kit. Kpro 750cc injectors, Walboro High flow fuel pump.

My car will crank with a good fuse in and i can drive it for a little while. But sometimes i'll ...