Hondata

A company called ECtune has a launch control feature called 3 step. where you can have 2 different launch control rpms, what im asking is if kmanager or smanager will ever have this "3step". even though i dont see the point in 3step

here is a link to ECtunes features if anyone is curious
http://www ...

i need help with a turbo map for kpro its for a rsx with a peakboost gt35r turbo its running stupid rich all over the place. there is knock count cranny but i can pull that out its just idk how to pull fuel for wot

i knew since im higher up in elevation than where the map was dyno tuned at and with the colder air was going to be an issue so im kinda woundering if im going to have to go through this again once it warms up but like i said ill use the map cranny made to see where the car is running at

ok i will give it a try but my elevation is 865 feet above sea level but yeah ill use cranny's map after school im in class right now.

well it wouldnt even change into column 10 to put the AFs where they needed to be if i just load the regular map in then the AFs are like 14 with the load index changed the air fuels are almost to rich but its a lot safer than 14 consistently

here is the datalog for that map with the load index changed it runs almost to rich now but its a lot better than what it was i will run the map you made later today

yeah i know check out this kal at column #10 and 9 on the edit load index

here is that datalog but i fixed the problem i edited the load index for column 10 and lowered it down a little bit but i still am going to run a datalog tomorrow i think it may need to be leaned out a little bit im not sure

i think because im running lean is because the kPa for the map sensor is to low because in those datalogs the map sensor is only reading like 98.something and column 10 is set at 104 which would explain why im running lean top end. so do you think if i set that down i will run where i need to A/F wise

i hope this one isnt completely useless

ok i was just woundering im still really new to this kpro stuff and been watching hondata's videos they made about kpro

thanks man i appreciate that i didnt really excpect for anyone to help me out i worked on one fuel map but i didnt put to much fuel at all to it but i cant run a datalog due to the fact there is black ice all over the place but thanks cranny ill let you know tomorrow if ice is gone oh yeah but by ...

ok i did a datalog with the car off and it said on my map it was -0.9 psi?¿?

i was on crsx magenisum noted that my TPS was reading 102% and my maximum TPS setting for it is 100% so ive changed the maximum setting to 102% so im woundering if thats why im not going into column #10 or thats why it might be a little leaner on top end. But the down side is it just got done ...

well i would have done 2k instead of 3k but cars was coming and couldnt slow down enough and i looked at it more my self i noticed my air fuels are running 14s in the high rpm range like above 7500 so i set my rev limiter to 7500 till i add some more fuel but still havent really learned how to add ...