Hondata

I hear that. I will try another run and post a datalog.
I have a dumb question. When datalogging should the car be in open loop or closed?

My bad it is K20A2 dyno tuned cai.
Like I said this is my first time doing this. I thought it was 3rd gear at 3k then floor it.
Btw my tps read 100% at 3273 rpm

Well I decided to do my first datalog today since it was about 48 deg out. I did a 3rd gear pull to redline.
From what I can see there are no knock counts, but the knock threshhold is all over the place. If someone can look at my datalog I would be greatful. I'm a noob and am still learning what to ...

Is there I way to tune the TPs thru the Kmanager? Mine reads 1 and from what I read it should be at 0 or -1. Is this correct?

Ok. I will try that. I have one last dumb question.

Can I upload a K20A2 RSX-S (prb) cal to my EP3 Civic SI with K20A2/6spd swap?
All the Civic SI PNF cals are for a K20A3.

Thanx

Yes, I understand that, but I don't have a copy of "the ECU calibration".

Should I just upload a new one?

Which one best suits my setup?

Is there a way to just upload the software to the ECU?

Srry bout all the noob questions.

Long story short. I bought this car used with the Kpro. Orig. owner used a cal from this older ver Kmanag. He doesn't have a copy, but told me it was prolly k20a2 tuned stock, maybe? He can't recall. I've been doing alot of research and have watched the videos that I can d/l. I'm wanting to datalog ...

My car is not boosted.
My questions weren't answered.
I don't have that kinda money to go get dyno tuned.
Any help would be much apprecitated.
Thanx

-serial number of your K-Pro>>>> It's older model #01??
- the calibration (as an attachment)>>>>One of the maps that came with it. So I'm not sure.
- a datalog of a problem (as an attachment)>>>>Not sure if I can do this
- what sort of vehicle you have>>>>See sig
- what sort of ECU you are using ...