Hondata

hmm, microphone shoudnt touch ground anywhere in my installation.

microphone is installed inside plastic ear protectors so it shouldnt hit ground anywhere. ear protectors are connected to copper tube thats attached to block.

hondata ECU isnt touching ground either, its rolling loose on carper atm ...

Hi all,


I found odd problem with S300, i took some time to build own knock sensor system and now i have problems with it, i'm not sure if I have hardware conflict with my laptop so could anyone confirm, if they can datalog with microphone plugged into laptop?

I use normal connector microphone(not ...

Hondata's answer got me lost here :D

I though the situation here is that ceasar wants to tune high speed ign/fuel maps which are maps that car uses when vtec is enabled, correct?

if he disables vtec, he wouldnt be using high speed maps at all?

and to tune the vtec tables, best practise would be ...

I tried to make adjusted values for 16x20 map and this fails... is there a bug?
what happens is that when I go for boosted tables, see 16 vacuum cells.. I add some cells to left(so last cell has value of 0.5), then save map.. exit smanager and start it again. then I load my saved map and boom, it ...

Hi,


I noticed in S300 that I can use it to show 5 bar maps, can I safely edit those boost values down, so it only uses vacuum points? ie set cell 24 to be 0.5 vacuum, as its in N/A tables?

and if I can safely do this, would there be any point to do it? are 10 vacuum cells enough and is that 24 ...

Hi,


Would it be possible to get Import Datalog (.csv) function for Smanager? or external tool for conversion?

i'd use this to edit lots of crap out from my daily driving datalogs and import edited datalog back to hondata to see how it looks..

no I didnt cut resistors yet, I thought it was just causing wideband readings to be more narrower as described in some other problem thread.

but i'll do that :)

all units are AFR currently in settings.

does cutting resistors affect anything else?

Yes, d10 is going straight to aem gauge white wire

edit: I edited first post littlebit so its easier to read. homever biggest question in this post was that when everything has been setup way I did, what voltage output should hondata ecu send to D10(eld?) its assigned as wideband lambda connector ...

Hello all,


I installed Hondata ECU(according to pages, its p28)+Hondata S300 and AEM Uego gauge wideband lambda to my car. Its running b18c5.

Homever I ran into problems calibrating this lambda to S300.

Lambda sensor is installed around 5-10 cm after original o2 sensor and its before ...

Hiyas all,

I just got S300 and aem uego wideband lambda, can I replace my original o2 sensor with wideband lambda?

car has b18c5

edit: appreantly I can, anyone confirm this?

Will aem uego act as regual lambda and as wideband lambda at the same time?