Hondata

Hey there hondata, I just can't figure it out.
What is the target a/f ratio on an OEM wideband to get the maximum power out of my 08 civic si's top end??? 5000rpm+

I have injen cai/vibrant ... header/vibrant 2.5 in exhaust/stage 2 skunk2 cams with upgraded valvetrain/ported 69mm 06 tsx TB ...

Hey there hondata,


was wondering how accurate the primary 02 sensor a/f ratios are?
does it read rich or lean or is it accurate?

I swapped out the stock tb with the 06 tsx tb and it does idle a little higher at first, then when driving, slight rev hang comes back but still ok. when cruising then shifting into neutral, then engine dips down to 500 rpm, then jumps to 1500 rpm, then repeats.
I have i/h/e with stage 2 skunk2 ...

Was wondering, since there was no tutorial for desktop computers.

How do you upload a new calibration map into my car using a desktop computer that is not close to the car?

How do you upload a calibration map onto the flashpro, and then disconnect it from the computer, and then go to the car and ...

Hey there hondata,

I have an 08 civic si with the following modifications:

injen CAI
Vibrant ... header
Vibrant 2.5 catback exhaust
Skunk2 Stage 2 cams with the valvetrain upgrade.

I saw on 8thcivic.com that you had the new skunk2 stage 2 calibrations maps available for the flashpro for this ...

What did Skunk2 say about this?

I didnt ask them yet, but i just put back my mugen catback exhaust and the problem is solved. The mugen catback is 50mm up front, then goes to 57mm near back of B pipe, and then 60mm from axelback on. It turns out that the 70mm skunk2 catback exhaust was just too ...

delete this thread please, i am no longer using it.

OK,

I was wondering, what parts do I need to change in my 08 civic si so that K-Pro will work on my 08 civic si?.....I will be taking parts from an RSX type S engine and wondered what parts need to be interchanged so that the K-Pro of an RSX will work for an 08 civic si???

and I would like ...