just a little question.
i am not offense to the tuning or knowledge, i just don't understand why the fuel table for table 2(full throttle, vtec table), different column will cross each other and not smooth? i know different engine have different tuning n i did see some tuned map look alike.
can ...
Search found 3 matches
- Mon Oct 27, 2008 7:21 pm
- Forum: K-Pro Calibrations
- Topic: Knocking at Lower RPM
- Replies: 24
- Views: 14357
- Thu Oct 16, 2008 10:22 pm
- Forum: K-Pro / KManager
- Topic: VTC
- Replies: 1
- Views: 1882
VTC
I am a bit confuse about the sensor in my kpro.
it had 2 sensor for VTC, one is CAM and the other is CAMCMD.
the CAM sensor (actual VTC cam angle) always show 0 and the CAMCMD (command VTC cam angle) is what my VTC cam angle show on my map. (datalogged)
does that mean I am running the command ...
it had 2 sensor for VTC, one is CAM and the other is CAMCMD.
the CAM sensor (actual VTC cam angle) always show 0 and the CAMCMD (command VTC cam angle) is what my VTC cam angle show on my map. (datalogged)
does that mean I am running the command ...
- Fri Oct 03, 2008 11:00 pm
- Forum: K-Pro Calibrations
- Topic: k20a2 tsx cam calibration
- Replies: 1
- Views: 2500
k20a2 tsx cam calibration
Hi all,
I am new to hondata and learning about it everyday.
I am looking a similar calibration of my setup before going on dyno
my setup is:
k20a2
3" intake
R-crew header
no cat
2.5" exhaust
tsx exhaust cam
stock PRB IM
fuel pressure at 50 psi
i tried most of the map from my kpro, even with some ...
I am new to hondata and learning about it everyday.
I am looking a similar calibration of my setup before going on dyno
my setup is:
k20a2
3" intake
R-crew header
no cat
2.5" exhaust
tsx exhaust cam
stock PRB IM
fuel pressure at 50 psi
i tried most of the map from my kpro, even with some ...