Hondata

Yes, that's all I have done for my three switches.

One lead of the switch to the ecu and the other to ground.

I'll try downloading it again.

Any new findings about this problem?

I don't know if this is going to work or not but I entered these values to get the values I wanted.

Voltage: 0.00 5.00 5.00
A/F : 21.6 40.21 40.21

21.6 made 10.0 show up in the A/F box.
40.21 made 19.99 show up in the A/F box.

Hope this made sense and like I ...

Thanks...it works again.

I changed the mininum engine speed to 100 and engine load to -14.5. I left throttle at zero.

Basically I want the lowest values in there possible so the map would switch as soon as I hit the switch.

I'll try that...it's funny that it worked before though. I'll let you know if that works.

In the past when I activated the switch I would see the map switch in SManager. Seems to me that this stopped working for me when I upgraded to 1.3.3. The system sees the switch when I switch it on and off. I also have changed the switch to use one of the other switches that I use for data logging ...

All you'll have to do is go under:

1. Options
2. Sensors

Choose the sensor you want to look at and change the unit there.