Hondata

hmm still not understanding this.

on the vehicle side (obd2a) on pin a7, i have a wire in there.
When i trace that wire through the conversion harness, it turns into
a11 on the obd1 side.

I know theres lot of threads already, but none of them seem to be able to help.
I just recently got the boost control hardware installed onto my s300 ( by a hondata dealer ). Brought it home and connected the solenoid as shown in the tech diagrams. Went into the s300 and enabled boost control ...

^^
ok so i disconnected the lc1 and changed the setup to run off the stock o2
sensor. The car now idles, but just idles like crap, needs to be tuned.

another question, in open loop the idle bounces around a bit 800-1000 rpm and looking at the vacuum gauge the reading is around 15, once i switch ...

ok heres the deal,
I have the s300 installed in a p28.
I have the innovate lc1 installed and wired up as shown ( PLX wiring ).
First started up the vehicle and it was running and reading fine.
After 30 mins, the car stalled. Now everytime i start up the vehicle af
reading is at 7.35 then jump to ...

Hey guys, i need help with a start up base map. I've tried some calibrations on here for the h22's already and tried leaning or riching up the fuel map, but still unable to get it to idle without having to throttle a bit.

set up
H22a4
9.5-1 Compression
750 cc Injectors
Skunk2 intake manifold
t3/t4 ...