Hondata

many thanks for the replies

Yes it is reading correctly but I dont want the heater staying on permanently and burning it out, thus requiring a new sensor every month or so. I'm aware the the heater is only meant to be on initially and then shut off, my question is, should it then see 0v or does it always see a minor voltage ...

As per a previous post,

Can someone tell me what voltage I should see on the wires for the lambda sensor heater. i see close to battery voltage on initial start-up for round about 30 seconds, then it slowly drops, down through 9, 8 etc and eventually just fluctuates between 2.5 to 5 volts. Does ...

Its a K20A2 motor fitted in a Lotus Elise. The K20A2 is fitted in the UK Type R, same motor as your RSX Type-S I think.

It is fitted with a JRSC with a 3.4" pulley, PRB ECU with Hondata K-Pro Serial No 4822 and Honda Wideband Lambda, Honda Part No: 36531-PRB-A01 (2xBlack wires, 1xGreen wire and ...

Thanks,

Is there any way that I can check it for damage, can I meter across the pins and look for readings within a specified range? The cat was offered up to the car and marked etc then taken off again prior to welding, then re-fitted once welding complete. There wasnt any banging or any other ...

Hi there,

K20A2 engine from UK Civic Type R, fitted with JRSC.

I have just fitted a High Flow sports cat so that I can get my car through the emissions test (will be taken off again after the test). Prior to fitting the cat I was getting Zero error codes, since fitting the cat I now get 1 error ...

I have just recently bought a K-Pro'd PRB ECU and I would like to connect it up to an AIM MXL Pista Logger/Dash display.

AIM produce something called a Hondata board to interface between the K-Pro and their logger. This communicates via the RS232TX line from Pin 24 on the K-Pro 'E' Connector. I ...