Hondata

So i recently ordered injectors but i dont have the dead time values. Does any one know what they might be for a bosch 1600cc injector. The company i ordered them threw could only provide the number for 14 volts. 14volts= 0.850. Do i even need to know the values for different voltage?

no you cant hook it up like that.....you have to have a controller for the wideband. then wire that to the s300

before i re-do the wiring.... can you tell me exactly what to enter in the lamba conversion table. i know the help files kinda shows it but it looks different than the actually program. Thanks!!!

ill check and post later tonight.

yes i cut the eld(pin d10) and left one side hanging and the other side connected to the white wire. i agree with you that it is an installation error but i can not figure it out. should it work if i connected the white and grey wires how i stated below?

im having alot of trouble wiring this up. i have the plx m-300 i read the help section and still makes no sense about the adapter plug, so i went ahead and did it different. To recap what i have already done. white wire to d10. grey wire to d14. cut r136 and r138. disconected stock o2 sensor(still ...

the s300 keeps going offline when i start a log or and in the middle of recording. and most times when i look at the graphs for a log....it is just staight lines going accross as if it didnt log anything. and i cant get them to download. i am new to the s300 so anyhelp would be greatly appreciated ...

thanks for the basemap. i used it on my lsvtec with 1000cc injectors and a 60-1. it actually work well. waiting to go to tuner but as of now can still drive around with this tune(no boost though :( )....anyways thanks again!!

here is a tune i found on here a few weeks ago. 880cc injectors. 60-1. b16. 3 bar map. i used it for my lsvtec with 1000cc and it still started perfect!! it will work better than that basic one ur using

contact joe demaree. Best tuner in the area. used to own ssc but they just closed. he is still doing street tunes...

Spunkster wrote:All US ECUs have them

Where are the resistors located at?

i need a basemap for a lsvtec motor built and bored to 83mm. with 1000cc precision injectors. sc6031e turbo. i just need sumthing to get it started and the tuner can do the rest. thanks!!!