Hondata

nope just have the one laptop. it gave me no problems on the older version?

with the latest version, mine has been having trouble uploading changes to the tune. the bars will move across till its almost done, then it will stop and try at least 3 times before i get a failure to upload. if i switch usb ports it will upload off of one usually, but not always datalog off of ...

what did you do to fix it?

i have something similiar, but mine is much earlier at 2k rpm. where is the CN2 4 pin header and how can i check it?

I took my car to the drag strip on fri night, and it developed a strange problem that i need some ideas with.
setup is as follows;
91 civic hatch
built ls/vtec @ 12lbs
hx35
tial 44mm
precision 600hp intercooler
walbro 255hp/1000cc inj
S300
obd-1 conversion & new distributer

street tuned on 91oct
it ...

version 1.3.6 is not letting me input any #'s into those boxes, they just revert back to initial settings after i input my #'s. even on a loaded tune they revert the #'s back :x

i agree... just think spunkster, you wouldnt have to answer all these wideband questions :lol:

turbo-charged do you just use one of the analog inputs to plot your FJO?

ok will do.

was i correct in my thinking about which points to enter?

ok perfect.

as far as the 2 points go i take it i only need the beginning and end?

ie; 0 volts 2x0+9.6=9.6AFR & 5 Volts 2x5+9.6=19.6AFR?

one more thing, i have the pr4 ecu. which jumpers do i need to cut for the d10 pin to read afr correctly? r136?

i am aware that the image is the old software, that was part of my question. why were there so many boxes to plot the afr vs voltage, and now there is only 3?

Now, in my case... would it be be better to use the analog input, where there is 22 points of reference starting at .15v and ending at 3.27v ...

i'm having a bit of trouble finding where to input my voltage vs afr for my zeitronix wideband.

right now i have it wired to d10, when i go to input the voltage vs afr, i only have 3 boxes to plot the curve. if i go into settings > analog input, i can't choose the d10 pin.

what i dont get either ...

i'm trying to figure out the same issue's as you were chriscrane. did you ever get it to work with the zeitronix?

the confusing part to me is which output to use to d10. the analog output or the linear output? plus the fact that the s300 wants lamda and the chart is in afr?

does just changing the ...

thanks, thats what i ended up doing, for some reason i had it in my head that it was just an update to the previous version, not the entire program. :oops:

how do i update my current smanager when i can't connect my laptop to the internet?

i can put the updated version on a usb device, but then how do i get the smanager to recognize the update?

thanks.

lol...in regards to the wideband signal? the signal is straight ok, so the voltage vs afr is easier to input?