Hondata

ok im still working on these freaking maps, ive made a little progress but im still having problems with my partial throttle being all over the place.


if someone could just post up a pic of how the 2d fuel graph should look throughout the rpms, that would be great as i cant for the life of me ...

and here is a newer version i worked on today.

open loop from 4 to 6 grand is holding low 13to1 afrs and higher then that is dropping down into high 12to1 afrs. wot is for the most part tuned.

does anyone have tips to tuning throttle??between 2 and 3 grand im hitting high 15to1 afrs, which is ...

worked on the tune some more let me know if im goin in the right direction or not? thanks

by the way i have only worked on the low cam fule table and that is it dont pay attention to the other maps

someone has to have some advice for me cmon people

k so im trying to learn the s300 and tuning here.

i have the s300 on a p30 with a plx wideband just to tune the afr's for now.

i have only messed with the first 5 columns, the columns 6-10 havent been touched yet. i know that the first 5 columns are choppy but i want some insight and if you want ...

thats the instructions we went by. its a p30 ecu the input is through the eld, do we need to cut the resistors?

and what is everyone using through the fuse box? because we took an ohm meter and couldn't find anything by switch power???


thanks for the help

just bought a plx sm-afr. hooked it up through the eld and ground to the battery. i dont have a afr gauge.

at first the o2 voltage stays around .5v and is right around 14.7 on af gauge through s300. but after a little bit the voltage jumps up to .9v but the afr stays at 14.7. trying to figure out ...

wow chan\ged the directory to C:\SManager and its fine....

Can anyone help on keeping the ELD intact using a PLX wb02 with a JDM p30.


Everything is hooked up just need to have an input that will work with the S300 and a stock JDM P13

JDM P30 ECU Hondata S300, newest update and drivers.

This is going on a 94 Civic with a JDM H22a.

Program worked fine until we hooked up WB02, then it did this:
"Floating Point Division by Zero" Everytime I click anything in S-Man.
I've tried the older version, 1.3.4 and 1.3.6.

Nothing I can ...

I'm deciding on a swap for my EJ Coupe. And its between a H22a and an F20b. Anyway the problem right now is running the F20b as far as ECU goes. I want to convert it to OBD1, but would like to run Hondata on it. But I really need a base map for that particular set up. Is there a basemap for the F20b ...

cmon some help if any would be terrfific

me and my brother have been looking to start tuning all of our stuff by our selfs through street tuning, and if we have to renting out a dyno. we just decided this with in the last couple days so we have been reading, reading, and reading.

I have downloaded the s300 program from hondata's site ...