Hondata

what ignition timing was used in that calibration? Thanks again Spunkster.

Do I have to run a narrowband sensor or can I just run off the wideband with my s300 p28? Thanks.

Spunkster wrote:Have you clicked the datalogging button to actually begin datalogging?

No, I just assumed when the engine is running the sensor readings would show up. Sorry, I am a newb to hondata. Thanks for your continued help though. :D

96 gsr, internaly stock,JRSC 6 psi, p28 s300 socketed by you guys, plx m300, rc440's,walbro pump,stock map sensor with map bypass,oem ngk plugs. Downloaded the most recent s manager. Loaded your b18c supercharger calibration. Car fires up fine, idles perfect, good throttle response. Whats wierd is ...

When I download the jrsc 440cc 12 ohm injector calibration, why does the current injector size show 510cc? Thanks.

I will be ready to fire up my jrsc gsr this week. Are there any updates for the s300? If so where do I find them, thanks.

I called moss motors (Jackson racing) and they are not familiar with the part. Where can I buy one? Thanks.

Is the map relocator neccesary on a 6psi JRSC, tuned with s300 and 440's? Thanks.

Ok thanks. What other input options in that list will I have? I dont have my laptop yet or I would look myself. Thanks.

I am replacing the stock narrowband with a wideband. Have a obd2b socketed p28 with S300. Do I wire the white PLX M300 wire to the primary o2 sensor wire, ord to the ELD input wire? Thanks for any help.

Forgive my ignorance. This is my first time dealing with anything other than a stock ecu. If there is no alternative or way to make this work then I will sell the ecu and get another one. But what is stopping me from buying the one plug that is different, and switching around all the pinfits at the ...

Thanks, thats exactly what I was looking for. Looks like connectors "A" and "C" are shaped the same. But connector"B" in the obd2b pic is shaped different than the connector "D" in the obd2a pic. So do I need a "B" connector to swap my wires into?

My gsr is a 96, and the ecu is obd2b. So I need a jumper harness huh.

I have a P28 ecu modified by hondata for obd2 plugs, S300 installed. Sticker on side says p28 obd2b.Where do I find a diagram of pinouts for this particular ecu? Are all pinouts in the same spot as a stock p28? Thanks