Hondata

Hi Hondata. I was wondering, are you guys going to make some kind of app for the newer smart phones (Droid market).

Hi Hondata I came across this in DIY water methanol at clubrsx.com . I have a 05 rsx type s JR supercharger with Kpro. I don’t understand what is written below.

ATTENTION 05-06 OWNERS. DO NOT USE CONNECTOR GOING INTO YOUR WIRE HARNESS. You need to pull out the connector with is plugged into ECU ...

Thank you! :D

How do I find what wire d10 is on a p28 ecu?

Would there be a difference in AFR in the S300 than the PLX SM-AFR. I thought you needed the gauge to set the difference.

Also do you have to calibrate the sensor in Smanager for the s300. If so how do I do that?

Hey I cant remember. Do I hook the PLX wideband as the primary or secondary o2?

Oh yea. That makes sense. No i dont think I have one. Hey thanks.

Oh sorry.... Well the car dose not idle to go so I dataloged it at idle for a few minutes to see what the low cam fuel tables looked like. It was warmed up for a good half hour. It showed that it was idling 10.04 af and needed to take away 30 to 45 percent in columns 1-3, so after making adjustments ...

Oh here is the cal.

Its a 98 prelude with a h22a motor. It has intake header and exhaust. The ecu is a p28

Thanks
Kam

I'm not sure how it will not let me? here is the data log and cal file.

Good morning Hondata.

I had just got a s300 for my h22a everything works fine but I can?t adjust the fuel. Even when it is in open loop the tune can?t adjust for itself. It idles the same as closed loop. Stinking rich. Any suggestions? :?:

Oh and what do you people recommend to have the lower and ...

Good morning Hondata. Hey I have been trying to get a hold of one of your dealer C-speed racing in Bellingham Wa for three weeks and still cant get a hold of any one there. They just will not pick up there phone or get back to me with the messages I had left. I have a virgin p28 ecu and need to have ...

hello Hondata. I could not find anything about purchasing ecu's from you guys? so here is my question. Can I Buy a p72 ecu from you guys with s300 program? Do you make adapter wiring harness for the ecu? It would be for my h22a1 99-00 civic project.

Thanks
Kam

Hondata what are your thoughts about wrapping the header and exhaust system with heat wrap. Will this help reduce heat soak to the m62 blower?

I have a k20z1 rsx.

Thanks.

How do I street tune ignition without a dyno ? Or is that the only way to tune ignition? Well correct me if I am wrong but can I just keep advancing by two degrees until the knock sensor picks up knock then start retarding ignition? I know that too much ignition advance detonates and causes knock ...