Hondata

VC! wrote:The belt size you will need is 40340, compared to the SIR / GSR / ITR pulley which requires a belt size of 40315.

thanks VC, once again your the man!!!

VC i just bought a crv crank pulley, do you know if i will need the jrsc crank to altinator boost belt?

the new version hondata smanager software has virus called klone. I installed it but it won't open and a box pop up and says that it's not able to execute to program. can you guys check on that?

i'm using the hondata 4 bar map sensor but i cannot find the hondata 4 bar map sensor setting in the s300 manager. i already look under parameter then map and then i look at the list of map sensors and theres none. the only 4 bar map sensor on there is the omni 4 bar and the rest are 2, 2.5, 3, and ...

thanks VC!!! your the man

vc,
can you go on my other forum under hondata application and read my post on s300 install for jrsc map relocator?

thanks vc

my question is what is a map relocator? i just install a jrsc and hondata s300 ecu and i didn't install the jrsc fuel enrichment relay system because i'm using hondata. when i gun my gas pedal it will sound like something is bogging kinda of like backfire. can it be that i need a map relocator, i'm ...

thanks VC, but i don't need it anymore. i went back and double check everything and it was my spark plug wires that was routed to the wrong plug on the distributor, dang i feel so stupid. it's working fine now. can i contact you in the future for any questions about jrsc ?'s ?

I install a JRSC with Hondata S300. In order for my engine to start I had to give it gas while I start it. when the engine starts it idles really ruff, shaking the motor back and forth constantly with backfire then it dies after 10 to 15 seconds. Can it be that my timing is off or the ITR JRSC ...

I install the P28 with s300 and uploaded 2001 itr base map onto my 98 spec jdm itr engine running on gsr harness and it's throwing a check engine light. when i data log, the error box said knock sensor and when i try to delete the dts it will disappear but it comes right back. i went to misc. tab ...

After i got the P28 ECU chip with S300, i follow all the installation instruction and i plug it onto my 98 gsr with a 98 spec jdm itr engine swap, and turn ignition on and the check engine light comes. i data log and it says knock sensor, how do i fix that? i already try to delete dts but it comes ...

how do i load the base map onto my new hondata P28 ECU using it on a ITR B18C with JRSC? I just finish installing the jrsc and do i just plug the ecu and start the car or what should i do? help please, any info will be greatly appreciated. thanks in advance.

I bough a S300, is the fmu required or does S300 replaces the fmu?