Hondata

make sure your not data logging when you try and dl from the ECU.

One thing no one seems to know is what the air fuel ratio is supposed to show when your antilagg is set up properly, i would think extra fuel means rich hence why some people blow black smoke, but no matter what settings i try my wide band reads all the way lean. i can build the boost i want with as ...

thanks a million, that confirms the numbers i came up with as well, thanks.

I noticed that my AEM boost gauge is reading a few psi off of my data logs, i also noticed there is no option to choose the gm 3bar in the drop down menu, i am currently set to motec 3 bar, I imagine its not good that my ECU sees 2 psi less across the board then what i am actually running, so does ...

are you sure your at d10 on the harness and are you setting the hondata config to read off d10?

does any one know which sending unit on a d series that hondata reads from? is it the same one as the dash gauge reads from ? i doubt its the sending unit but i have to start some where.

how can i change where it reads from? we tested the temps using laser readers and my thermostat is a 180. my dash gauge never goes up more then 1/4th as well. i need to get this sorted so i can properly set up the ign compensations. one last thing i have done is turned the fan on and the hondata ...

Does any one know why when i am driving around hondata reports my ECT to be 206-208 yet my car is actually running 180 to 190? any ideas? yes i have the newest release.

i think my ecu is a p28. where do i buy these diodes and transistors?

I have hondata s300 running my CRX, do i need to buy anything aside from the solinoid to use the ECU to control my boost ? i mean does anything need to be done to my ECU aside from whats already done?

Hi guys, we need a tutorial on how to make displays, aside from the basic create a meter or guage that is easy to figure out, i want to know how guys are adding photos as backgrounds, i tried for hours to alter and or add back ground jpgs or bmps and have no luck. so can some one post info on how to ...

still same issue, when i try and export a movie it simply says error writing file, it dont even get to the point where i can choose codec. it simply says error writing file as soon as i choose export movie.

thanks spunkster, its working great, but i noticed it wont data log lower then 1.3 volts or 12.2 AFR any ideas why?

if the mil light is a ground signal why bother use a diode? the relay could trigger from the ground with out feeding back and signal right?

Bump, any one know how to get the AF cell in the sensors window to read anything besides 0? the ELD cell is reading voltage from the wide band its just not converting it to a AF ratio.