Hondata

just got my ecu back. also came with a 05-06 wiring harness. now i already have an 05-06 harness, but i need to know if there is any differance between my older harness and the new one i just received. thanks in advance for the response.

I looked at the form and was confused as to who i should send my ecu to. do i send it directly to hondata? also do i just state that i need the ecu to be compatible with an 05 rsx type s with a k24a2 swap? let me know so i can send this out.

Spunkster wrote:No the only solution is what I mentioned above.

ok well i have an eps setup in my car with a dakota speed converter will this be affected if i do this upgrade?

The ECU would have to be sent in to be upgraded to work in an 05-06 RSX. The cost for this is $250. You would have to fill out the K-Pro form and note what it is you want done and include a cashier's check for the full amount.

so its not possible to just ground out the sensor? I dont understand ...

Ok so how can I get this to work? Can I ground the vtc(-) to the chassis or run a wire to splice into the correct wire on the harness?

Spunkster wrote:What is the serial number of the K-Pro board inside the ECU?

05003782

ok here is the run down of my problem. current setup. 05 type s with full k24a2 swap. previously i was using a kpro prc ecu with the 05 jumper harness. car ran fine and never threw this code. i recently swapped my ecu for a kpro prb ecu. everything seems to run fine but when i give it gas it throws ...

well what is the best thing i should do, just load a base map on there, and not try and dl the program thats on there?

well when i got home thats waht i did, i hooked up the labtop downloaded the orgram from the ecu then saved it then changed waht i needed and loaded it, car started but would die when u gave it gas. i went to the tuner and he said that the reason it did that is because of copy right. but i talked to ...

1.2.2.9

i upgraded my kmanager before or after the problem happened i forgot what i did it was a while ago , i would like to say i upgraded before but it could have been after seeing i was trying to fix it

ok i got a tune from some shop. i went home and Down loaded the program and then changed my launch control. uploaded the map with the new launch limiter. the car start but sounded like shit. i gave the car a little gas and then it died. same thing happened twice more. i then was like o fuck what did ...

ok here is the story. i took my car to get tunned at a local shop (topsetup). he tunned the car and everything was fine...at first.

on the way home i noticed that my engine temp guage wasnt working. i figured no big deal i could fix it with kpro. later that night i went to use the a/c, light came ...