Hondata

Spunkster wrote:Please contact us individually to get an RMA number

i send you guys a email for the Rma number

your vtc doesn't work cuz u have CEL "Iat low voltage" i pritty sure ur vtec doesn't work also. i know there is somthing worng with kpro or the harness adapter because my stock ecu ran fine no check engine light at all. Could it be 1 or a few wire got hooked up wrong? to be honest i'm really ...

could it be other wires that hook up worng due to CEL light?
TPS,ELD, ECT, ETC?

If you are error codes with your K-Pro, please follow the troubleshooting steps below:


1) Clear security (Online, Tools, Erase ECU), close KManager and reopen it then go to File, New and create a new calibration and upload it.
try it, didn't work. code still there


2)If you have an 05/06 RSX ...

it doesn't throw any code when i'm using stock ecu. its only kpro..
do u have the wiring pic for the harness? you could send it to shui_fai@hotmail.com

oem b17 to harness b17

its been more than half a year i havn't got the problem sloved. i was always ask to check the helm and check the wiring. well, it clear i checked before i ask hondata for help...


HONDATA

serial number of your K-Pro (4087)
- the calibration (k20z1 dyno tunning supply by hondata)
- a datalog of a ...

i am having this problem also, i've have check the wiring, replace the sensor nothing slove the problems. Hondata never help me slove this problem.

could i take off the harness and see if my harness have problems?
engine is lit on onces i install Kpro.

Spunkster wrote:Yes you can try it on any RSX, just don't use the adapter if it's an 02-04.

today i took out my Iat, and figure out its cooked/melted. could there be a short somewhere?

Spunkster wrote:There is no need to buy a harness since you have not completed all the troubleshooting steps yet. You need to try this ecu in another vehicle to see if it is getting the same IAT error there.

there isn't another 05-06 rsx i could try on.... could i try it on an 02-04?

could i only buy a new harness?

when i unplug my IAT kpro is still throwing " IAT LOW VOLTAGE" and the temperature reading is the same 95f.
what should i do? my turbo kit is comming in next week... i want to get this fixed. i don't want to use Emange!

type-s ecu/ 05 base rsx.

Spunkster wrote:You have asked this before. You must use the 02-04 o2 sensor with the K-Pro. You are trignto determine if there is a problem with the IAT, so don't worry about other errors when testing. Just look for the IAT error.

i've change the 1st o2 sensor, do i need to change the o2 after the cat?

Spunkster wrote:The sensors are all the same. Please try the ecu on another vehicle. This will tell you if it is a problem with your ecu or with your car.

will i have check engine if i ran my stock 2005 ecu with 2004 o2 sensor?