Hondata

In the Installation Manual it says to swap the RP18 resistor for one 1 K ohm less to change the P30 JDM EG9 ECU to manual. Someone at Hondata technical said instead to remove both RP17 and RP18 and then add a jumper to RP18. This is what I had done after clarifying it three times with him. The ECU ...

I have been getting a code 19. I have a P30-941. Is that automatic? If so, I am looking for RP18. Where is it? On the daughter board, there is an R18. I am doubtful that is it as I understood the DB was for the knock sensor.

Also, I have been getting the code 20- electronic load detector. I have a ...