Hondata

i have the plx wideband installed (wired into the eld wire) and i have noticed my car doing funny stuff as of late. yesterday i was driving and noticed my car doing weird things when i let off of the gas. it would sound like it was revving down and then hiccup around 2000k rpm (it would like stop ...

After about 6000RPM datalogging of AF cuts out. Hondata continues to datalog everything else except AF.

I've got an Innovate LC1 connected to D10 ELD.

have you verified that it is correcting datalogging before 6000rpm?

im stumped on this one so far and have to think its either a wiring or ...

with a setup like that id be towing it to a tuner... the price you'd pay to ensure the longevity of your motor is insignificant in comparison to the price you paid for the parts.

i always joke about how my integra sounds like a p52 mustang... i really would feel like an old fighter plane with some methanol rofl.

Check these links out... doing these two things greatly improved my idling.

How to Clean your FITV

How to Clean your IACV

Can someone please tell me when setting it the way the service manual tells you to is wrong, i mean i had it at 0.48 at idle and 6.8 at wot adjusted all the way to one side as per the multimeter........ when i moved it to the middle and hondata reading 5 volts at idle the car fixed itself. I don't ...

when the computer is turned on...the light should be green where the data cable connects to the ecu correct? because there is a red light and a green light..i only remember seeing green before not the red? am i correct or incorrect on this?

I believe the red blinking light is normal function when ...

No, you should not have to retune, but the aftermarket ignition systems often cause interference with datalogging.

I have used a MSD Distributor with my s300 unit and intereference can be an issue.

Dont forget that Honda ignitions are sufficient for upwards of 400 hp! Hondata alone should be ...

wrong forum, check out s300 calibrations

GI8U2racing wrote:The tak is back! The guide I was following on H-T for the gauge cluster swap has the VSS output wrong, so the ECU wasn't getting the right signal. I just traced it on the back of the cluster and figured it out.

whew, glad you narrowed it down.

ls basemap with 2.5" catback and intake 7lb flywheel stg2 clutch

i guess like a "tune" for that kind of stuff.

never did tuning before so idont know whats possible

kindve late to be responding but you should be fine using the stock b18b1 basemap which is included with smanager. i doubt the 2.5 ...

start with a stock timing map, retard 1 degree per psi in boost and tune your fuel maps accordingly. start with values you know are going to be rich at your lowest boost setting and then lean it out as needed. its really pretty easy to get a decent street tune before driving to the dyno.

yeah ...

albastiki wrote:Hi everybody. I want same help please. Can I use any EGT sensors with greddy EGT electronic gauge?? And Thanks

wow, doubt too many people know much about greddy products here.

ok. i have now bougth a plx wideband, and installed it, but the speedometer is still not working as it should.
when i cutted the original o2 lambda, it was a spark from it.
is a spark enough to kill the speed sensor?
please answer me if anyone knows.

yes a spark is enough to seriously damage or ...

wow. wouldnt expect problems out've an '08 honda. i wouldnt expect it to shift as good as an itr tranny at any rate. have you modified the car in any way? it shouldnt be backfiring... ive had my integra for 10 years and have toyed with all kinds of timing curves and have yet to make it backfire. im ...