Hondata

I don't have a FN2 and my EP3 is tuned for 98ROZ, too.
It is just a question, because at Hondata.com you can't see which kind of fuel is required.

Hello,

What kind of fuel does the Euro 07 Civic Type R Group N ECU request.
Is it possible to drive it with 95ROZ?

Very good. We have nearly the same Mods.
My Email Adress is:

n_nilisse@hotmail.com

thank you, ill test your map. In september, my car gets tuned on dyno, too.
I'll send you my map, too.

Hello, I use the PRB map. I have given less fuel, at the points, where the engine runs to rich and now my A/F value is fine.
The car is now very strong. The Vtec hits much better, than before.

Hello,

Thanks again, for helping me to get the Kpro run :mrgreen:
I?ve a termin for Dynotune in September. Before that, i want to tune the car myself for the best A/F results.
In Germany the sprit for the K20a2 is defined "95Octane ROZ".
With the map "Dyno tuned K20 with CAI" the engine runs ...

I have found the error.
You can?t let the Signal bridged on E4 and A16, cause the signal gets to weak.
After cuting E4 the Signal Voltage claimed up to 50% and know it works fine. The ECL is now off :mrgreen:

Thank you for your help.

Hello, I?ve made the changes, but there is still an error :(
? P1162 Air/Fuel Sensor low res.
The lambda value is not changing. I have bridged E4 and A16.
A2 is bridged with A22 and there are switched 12V on the contacts.
I have enabeld OBD2 in the Kmanager and disabeld P 0134 (O2 sensor response ...

Thank you :mrgreen:
I think that will slove my problem. I have not seen the wireing diagram so far. I?ll make this changes first by my self, cause I?m technician.

Hello,

the Maps are running but I get a Failure from the first Oxigen Sensor. I use the RSX Type S Oxigen sensor. The Lambda Value is every time the same. Must I change some settings?

Now I`ve seen, that the RSX Type S has a complete different Fuel Tabel, than the Euro Civic Type R.
What can I do, to play the Euro Civic Type R Maps in the Hondata RSX ECU.

Thank you. I have tried the Map K20a2 Dyno tuned with coldair Intake, the car runs very strong in the midrange, but after 5000RPM there is less Power, than before :(
Can you say, which Map I should choose for Better Results?

I?ve found the error.
I?ve installed the RSX Typ S rom again, when the Engine was hot and the Watertemp is now shown in the Tacho.
The Engine runs very good.

Now I?m searching a map for my mods:
AEM V2
HJS KAT 200CPI
4-1 Idol Header but original catback
Where can I find more Roms :roll:

Hello,

I?ve bought a RSX Hondata ECU with the RSX Oxigen sensor and use a RSX Type S map at my K20a2.
My Problem is now, that the water Temp is not shown at my Tacho. What can I do, to make this work.

Sorry for my bad english, i come from Germany :lol: