Hondata

CAN I USE THE A3 MOLOTRON KAL WITH NO PROBLEM???????????????

anybody? :?:

I have a

k24a1
04 six speed tranny
exedy clutch
revhard turbo kit with the turbonetics 60-1 turbo 630 molotron inj

The only kal i saw that was close was
k20a3-civic si-revhard-molotron inj

Its labeled as 650 injectors in the parameters which is close enough to tune from but will i have a ...

I have a

k24a1
04 six speed tranny
exedy clutch
revhard turbo kit with the turbonetics 60-1 turbo 630 molotron inj

The only kal i saw that was close was
k20a3-civic si-revhard-molotron inj

Its labeled as 650 injectors in the parameters which is close enough to tune from but will i have a problem ...

How do you change the rpm intervals while looking at fuel tables. At low rpm it goes by 250 rpm intervals. EX: 2000-2250-2500-2750-3000. At 4000 rpms it starts going by 500. Is there a way to change this? Thanks

Rob

When posting a KPro problem with your vehicle, please include:
- the calibration (as an attachment)
- a datalog of a problem (as an attachment)
- what sort of vehicle you have
- what sort of ECU you are using
- anything about the car which has been modified from stock which may affect the ECU (don ...

Well i had to -4 ignition degrees in the areas of knock, and i messed wi the air fuel. the air fuel needs some more work, ill mess with it tomorrow heres the new kal and some more datalogs if antone wants to check them out. Thanks rensoyka! heres the new kal and some uphill datalogs

rensoyka did you look at the kal? if so what do you think?

I started with the k24 accord kal
Injectors are stock 270
The block and head are bone stock

setup:

k24a1 with k24a1 head
stock header
ep3 intake manifold
stock exhaust
exedy stage 2 clutch
rsx type s flywheel
aem cai

who is it?? also could you refer him to the post i put up on hondata.com Its labeled choppy air fuel, i could use some help,....good luck man

you should go to 2500 rpms and floor it, then part throttle will be tuned after that. Can you floor it and not hit lean control? my guess is its gonna be rich as hell...

none of those datalogs are wot. they are both the same thing....pt your tps never goes over 40%

anybody???? Inoticed on the high speed fuel table at 5500 rpms the numbers go down???? Is this normal because it dosent seem to do that on any other map but im not going to lean...Im confused. Also will smooth selection fix the choppy air/fuel curve?

You get lean cut out at wot or only on pt? By the way do you have aim?

Is this the map your using and you just changed the name?