Hondata

I have done it with detailed description. Is there any other way to reset the firmware or to force download the old one?

Yes and i install it to two different laptops but no differense

I dont know maybe from where can i understand this? In kmanager the button update firmware is greyed and when the ecu is disconected from the car and conect only the usb the green led is on for a second and then off and the red led blinks very fast?

I have done it but i have the same mesage again. I have tryed even my wifes laptop with new installation in case that mine have someting wrong. Is there any way to hard reset the firmware and uploade it again? I tryed reset ecu, leave it for 5 minute without power and again the same. The only thing ...

my car is civic ep3 pra europe with kpro v4. I have changed laptop and to the new one i have installed the version 4.6.3 but to the old laptop i had the version 4.6.1 of kmanager. The first time i connected with kpro with the new laptop the kmanager told me to do firmware update and i press ok but ...

is anybody here using the stock knock control logic to a tuned engine na or turbo or supercharger?

so when i have long term fuel bank for example -3% and i am in wot the fuel maps is still trimming -3% at wot (open loop). Is that correct or at wot is the fuel maps without trimming?

yes but my question is if the the trimming from fuel bank in closed loop is trimming still when i am in wot (open loop) or not

When i work in closed loop and the ecu is trimming the maps for example 4%, when i go full throtlle so i am in WOT so i am in open loop, the trimming from closed loop the 4% is still triming from the maps or the trimming is working only when i am in closed loop and when i go to wot is the maps ...

It hapened to me when the batery voltage was low and the time i was loading a file and at the end of the loading the ecu priming the fuel pump the voltage drops even lower so i has this error. I load it again and let the car working to charge the battery and it didnt hapen again

in the PRA model the target lamda at idle settings is always grey and shows 7.35 and you cannot change it. But i was playing with the parameters and i findout that the target lamda maps for the idle is working only when in the closed loop advance settings i enable the "enable target lamda tables" if ...

Hello all. I have a honda civic ep3 type r (europian model) with k20a2 forged internal and rotrex. I am running kpro v4. I tuned the car in open loop and it is ok now i make it closed loop and everything works fine and the trims is between -5% and 5%. The only problem is that when it is warm and at ...