Hondata

Thanks for the reply. I'll keep trying with the voltage offset. Will post up the result.

Hi, I've managed to wire it all up through the ELD(leaving the narrowband front o2 sensor in plus am running a race header), getting a lambda reading and it's working except that the lambda figure in kmanager reads a little higher or lower to the UEGO gauge.
I've filled in 3 cells in the ...

Sorry, I should have written that there is no cat but would be placing the lambda in the second lambda position :oops:

Thanks for the help.

If I replace the second lambda(after the cat) with a wideband and then wire it to the ELD input on my euro CTR kpro. I can then datalog wideband A/F?

Problem with that is I can't even datalog any more as my .kal is from an older version of kmanager. The place where I got it mapped won't give me the map to up load again with the latest version of kmanager.
:?

Fixed it. The problem was it wasn't showing any error codes with obd turned off but the mil light was still coming on. I found the connector that was missing and it was for the front o2 sensor not the back so plugged it in and the light went out.
Thanks for replying.

Am running a dc raceheader(decat) on my euro type r and can't get the mil to go out. Have tried disabling the 02 heater in the closed loop tab and disabled OBD11 this works for a minute or two then the mil comes back on. If I turn the ignition off and on it goes away and then comes back. If I turn ...