Hondata

Spunkster wrote: Wed Feb 12, 2025 12:36 pm You would need to see if it uses the same conversion as other sensors in the list, if not you will have to enter custom values provided by the manufacturer.

Thank you I'm figuring it out!!

I would recommend that you use a mechanical gauge for testing and first startup as you may have wiring issues or other issues which may not give an accurate reading right away and by then it may be too late.


Thank you..
Will do

With my bosch pressure sensor..
It's a oil temp and pressure ...

Sensor 5V goes to an ECU VCC pin and sensor gnd goes to one of the ECU SG pins.

Use a 1.5k pull up for the temperature.

http://www.hondata.com/help/kmanager/analog_temperature.htm

Pressure gets wired in without a pull up.

http://www.hondata.com/help/kmanager/analog_pressure.htm


I have this ...

Hi ya.
More hunting. For oil pressure sensor I've added. I Nedd to take the 5v from e connector pin 5
Which is a yellow and blue cable.
I will then connect the ground and the input from the sensor to the new hondata analog card a01 ( red cable I belive) and the sensor ground to the black.

Does this ...

Morning all.
I am new to hondata, my ecu should arrive today K4pro.. whoop whoop
The engine is a K20 from a UK civic type R EP3, It is in a Toyota MR2 MK3

I have a question about first start up, before i start it up I want to know I have good oil pressure, Currently on my dash the oil light will ...