Hondata

Hi all! I've been working on my h22 euro r calibration for a couple months now and have gotten familiar with tuning in open loop. Problem is when I switch back to closed loop afr is way leaner than it was in cl. Also any pointers on tuning closed loop? I get I should go off my stft problem is my ...

Ok I'm learning slowly but surely I have figured it out. I had to change the idle area on ignition map 1st and then go online take it down to 12 degrees for euro r higher compression and cam profiles. It was messing me up not changing the actual idle area in my map bc as soon as I would close set ...

Ok I've got my h22a euro r in and running on stock h22 basemap at bottom of calibration list. Anyways my question is in calibration hondata set timing in the online menu is saying 16. Well I've been on euro r forums and they say it needs to be on number 12 mark printed on flywheel. Regular h22 usdm ...

Ok I ended up ditching jdm fuel rail and euro r injectors for regular h22 high impedance injectors and tried map again and car ran so much better. Thanks I really appreciate your help

Hello. I uploaded the map and tried running it but car idled so bad I shut it off and reuploaded the hondata h22 map at bottom of list. It cranks and runs really good with that one hell even 1st gear pulls descent. Anything after that though and the performance is just not there. I'm researching and ...

No it has not been tuned. I just got swap done and got wideband and ecu wired up. Car starts up and idles so good. I can even rev it up and down smoothly and it sounds really good. But when I go to drive it 1st gear pulls ok and anything past that it just gets boggy and jerky. I went from a 3 wire ...

I've swapped my f22a1 for a h22a euro r engine. I reused my f22 harness . I swapped 3 wire iacv for 2 wire with adapter plate. Used h22a1 distributor. Was able to use f22 rail and regulator with euro r injectors. No resistor box. P28 ecu with hondata s300. Car cranks up and idles great. Even 1st ...

Hi all. I have recently swapped my f22a1 for jdm h22a euro r. Car cranks up and runs on the h22 basemap but has very poor performance. I used h22a1 distributor. 2 wire iacv/w adapter plate. Also used obd1 egr as the obd2b egr was a different design. I have it running on p28 with hondata. I was able ...