Hondata

I have an interference problem. My datalogging cuts out on me. I have tried other cables, additional ferrite cores, shorter cable, better quality cable, resetting the daughter board, insulating the USB connector, removing my home made grounding kit, relocating the ground as recommended, two other ...

I guess my MAIN question is will the extra power FRY kpro or can I safely try it to see if it has any actual benifit or not...



E.

I noticed KManager's pulldown in the MAP Parameters lists all the MAP sensors that have support built in. I was wondering if anyone had any actual part numbers they can share for some of those sensors as well as the wiring harnesses to hook them up with.


Thanks in advance,



Eric

I was wondering if it was safe for KPro to try using a dual headed cable to interface with a laptop.

Basically I want to use a cable that goes from a USB male-B (Kpro side) to TWO USB male-A heads, one that has all pins active and the other has only power pins. This would be the same as seen with ...