I’m currently installing a k24 into a Jetboat - which will be powered by a cl7 / k pro ecu.
As I will not be running a transmissions ( Jetboat is direct driveshaft to flywheel) I will have a few wires and plugs redundant and was planning on removing from the loom.
My question how ever is with out ...
Search found 3 matches
- Wed Aug 28, 2024 1:22 pm
- Forum: K-Pro / KManager
- Topic: Running a k pro with no transmission
- Replies: 0
- Views: 4944
- Wed Aug 28, 2024 12:56 pm
- Forum: K-Pro / KManager
- Topic: Hondata/Accord CL7 ECU Wiring in a boat.
- Replies: 3
- Views: 2665
Re: Hondata/Accord CL7 ECU Wiring in a boat.
Thanks I’ll have a look. If I am not using a gearbox can I remove these plugs and wiring from look?
- Sun Aug 25, 2024 11:56 pm
- Forum: K-Pro / KManager
- Topic: Hondata/Accord CL7 ECU Wiring in a boat.
- Replies: 3
- Views: 2665
Hondata/Accord CL7 ECU Wiring in a boat.
Hello.
I'm currently installing a K24 into a jetboat, I have the engine harness, ECU and a Hondata ECU. The set up was running in a CL7. I'm just wondering how can get this ECU/ Wiring set up to work in a stand alone situation. I'm no wiring guru, but guessing I need to power up and earth the ...
I'm currently installing a K24 into a jetboat, I have the engine harness, ECU and a Hondata ECU. The set up was running in a CL7. I'm just wondering how can get this ECU/ Wiring set up to work in a stand alone situation. I'm no wiring guru, but guessing I need to power up and earth the ...