Hello again,
I have made myself a set of Det Cans to aid in this tuning process.
Doing some pulls, I can hear some of the classic Pinging sounds of knock.
It is not consistent throughout the pull. There is a distinct ping at about 4500rpm and a few more around 5200rpm
Attached is the log with the ...
Search found 4 matches
- Sun Dec 31, 2023 3:07 pm
- Forum: FlashPro Calibrations
- Topic: Turbo TSX basemap
- Replies: 5
- Views: 9352
- Thu Dec 28, 2023 7:17 pm
- Forum: FlashPro Calibrations
- Topic: Turbo TSX basemap
- Replies: 5
- Views: 9352
Re: Turbo TSX basemap
Hello,
Update; I have added some timing back in, in both low and high cam, and the over boosting is no where near as bad. Still creeps to 10 psi, but it does hold 8.7 psi longer when the gate opens.
I'm going to add some more higher in the rev range to see if it can hold the 9ish pressure.
Thanks!
Update; I have added some timing back in, in both low and high cam, and the over boosting is no where near as bad. Still creeps to 10 psi, but it does hold 8.7 psi longer when the gate opens.
I'm going to add some more higher in the rev range to see if it can hold the 9ish pressure.
Thanks!
- Wed Dec 27, 2023 8:37 am
- Forum: FlashPro Calibrations
- Topic: Turbo TSX basemap
- Replies: 5
- Views: 9352
Re: Turbo TSX basemap
Thanks for the reply!
Do you think the values in my map look too low for this setup?
I was having a difficult time finding good comparison values for a turbo k24 to know if I’m even in the ball park. Wasn’t sure if the supercharger map in Flashpro would be an Ok comparison. They seem really high for ...
Do you think the values in my map look too low for this setup?
I was having a difficult time finding good comparison values for a turbo k24 to know if I’m even in the ball park. Wasn’t sure if the supercharger map in Flashpro would be an Ok comparison. They seem really high for ...
- Tue Dec 26, 2023 8:53 pm
- Forum: FlashPro Calibrations
- Topic: Turbo TSX basemap
- Replies: 5
- Views: 9352
Turbo TSX basemap
Hello,
This is the current map I've made to run with my 2006 TSX with a G30-770
8.7 psi Tial spring on a jackspania sidewinder manifold, custom DP
1000c DW injectors with an aem340
The car runs pretty well, it still has some low load hesitation, but going WOT from 2k, it picks up great, full boost ...
This is the current map I've made to run with my 2006 TSX with a G30-770
8.7 psi Tial spring on a jackspania sidewinder manifold, custom DP
1000c DW injectors with an aem340
The car runs pretty well, it still has some low load hesitation, but going WOT from 2k, it picks up great, full boost ...